 |
Pigtails soldered on to speaker selector switch
|
 |
had to use 2 DPDT rockers because I couldn't find a 4 pole
double throw
|
 |
These switches alow me to select either the rear 4"
factory speakers or the new Pioneer 6X9's
|
 |
Hummm...Need room for the big magnets and the speaker
mounting screws must catch the metal structure
|
 |
Wire snake! Got the speaker wires to the rear and up the C
pillar and through the rubber tube.
|
 |
Bingo!! New speaker wires in the liftgate.
|
 |
Two 3/4" spacers that will go between the interior
panel and hatch metal. Just got to saw apart.
|
 |
Flimsy plastic panel. trim padding and ribs on backside
where spacers go.
|
 |
Time to install interior panel with spacers, pre drill
mounting holes and install speakers.
|
 |
Lock mechanism bent slightly to clear speaker magnet
|
 |
A little metal is nipped and bent back to clear speaker
terminals
|
 |
2" self taping screws go through speaker flange,
interior panel, spacer and tap into metal sub-structure.
|
 |
Finished. Plastic panel is flimsy. Speaker mounting screws
must catch the metal sub-structure! |
 |
View with liftgate up |
 |
Tunes out the rear! Ready for those tailgateing partys at
SEC football games! |
