Turn these bumpers in or out by hand to adjust the closing of doors or the hatch.

Click on image to enlarge

	Front door bumpers - two per side at the rear of the doors
	Slider bumper - one per side at rear edge of door
	Hatch bumper - one in each lower corner

Slider rattles may often be fixed by "floating" the plastic receivers that hold the door in position relative to the body.

Slightly loosen the bolts holding the receivers to the door jambs. Close the slider and gently push in on the front of the door to move the receiver as far inward as possible. Open the slider and then tighten the receiver bolts.

The hood bumpers are located at the front corners of the engine bay. They're threaded so you can turn them by hand to adjust how the hood closes. Adjust them if the hood is too hard to close or if there's any movement when it's latched.

	Left side bumper
	Right side bumper
	They're threaded, so turn them a little at a time to make the hood easier to close or to prevent up and down motion of the hood when closed.

<<< BACK