This mod changes the fog light wiring so the lights remain on with the high beams - a useful feature here in deer country.

Click on image to enlarge

	This is the "B" relay that was added during the Honda fog light installation. It's purpose is to drop power to the fog lights when the high beams are on.
	Remove the connector from relay "B"
	Spreading the shroud will allow it to be removed to expose the wiring
	Release and pull this connector. This prevents a pick at relay "B" when the high beams are turned on.
	Replace the shroud and tape the connector back to the harness.

For maximum flexibility, this mod adds a single jumper to allow fog light use with parking lights, low beams and high beams.

	Locate fog light relay "B".......
	...and disconnect the connector, then tape it out of the way.
	Remove the fog light switch connector and pull it back out of the dash.
	Locate the blue and green/yellow wires.
	Remove the tape and slide the conduit back to give yourself room to work. Strip back a gap in the insulation of each wire.
	Solder a jumper across the wires and tape the connections.
	Tape the wires and conduit back together and reinstall the switch.

<<< BACK