Click on image to enlarge

	One of the easier mods, installing a glove box lamp from a '93 Accord, per Hy's advice. Remove glove box by removing two screws, one at each hinge of the door.
	Remove four screws, then latch plate.
	Using switch as a template, mark and drill two holes in latch plate for self-tapping screws
	Switch mounted on latch plate
	I removed the grey plastic terminal housing from the switch to make room for push-on terminals.
	Ready to reinstall the latch plate.
	...and the latch plate reinstalled above glove box.
	Tie the wiring into the center bin light and ... voila, let there be light! Don't worry, you can't see the lamp assembly from the seating position; this is a view from INSIDE the glove box.

<<< BACK