Honda Odyssey Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter #1
I am aquiring a brand new 5 speed tranny out of a pilot from my good friend who is a honda tech. Honda is throwing the tranny into the garbage because the casting has porosity. I am picking it up today. The only milage on it is from getting it onto the lot.

The porosity will be JB welded, or I will replace the suspect part.

Can it be done? The obvious is the bell housing is the same, the problem will be what will control it. I have alot of research to do. Stay posted. If I can pull this off, this will be awsome.

What do you guys know about this tranny so far?
 

·
Registered
Joined
·
2,529 Posts
Food for thought?
Starter motor is different
Shift control
What about the front diff
Drive shafts

Keep us updated.
 

·
Registered
Joined
·
31 Posts
Discussion Starter #4
Ok here we go...tranny bolts up, but electonics are completely different from 2002-2005 oddy 5 speed tranny which I had though I would use to keep it simple. New 2011 computer has many different components that it controlls compared to the ody computer, so at this time I just left the tranny, in the crate and rebuilt my ody tranny instead.
 
1 - 5 of 5 Posts
Top