Honda Odyssey Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
I bought a winter wheel/tire package for my 2002 EX-L and I also bought the LX wheel covers from H&A. The facotory covers don't fit the winter wheels I got from the TireRack. Anyone else? What did you do? Can I modify the covers to make them fit tighter? Currently they go on but are VERY loose. If I were to drive they would fall right off.

George
2002 SSEX-L
 

·
Registered
Joined
·
122 Posts
The cover are supposed to be bolted on the outside. The shouldn't fall off.

Also you need new bolt from Trevor.

LX steel wheels and ex Alloys use different bolts
 

·
Registered
Joined
·
129 Posts
Uh Oh!

I installed EX wheels on my LX (2001) and reused the same lugnuts. They seemed to work
fine.

What have I done??

------------------
Nelson
2001 Odyssey LX - Silver
2001 Civic EX Sedan - Silver
1990 Mustang LX Coupe - Titanium
http://fiveoh.homestead.com/main.html

[This message has been edited by SoFlaOdyssey (edited 12-26-2001).]
 

·
Registered
Joined
·
40 Posts
Discussion Starter #4
When I put the cover on now, with the wheel already mounted, the cover slips right over the lug nuts, so are the LX nuts larger? Would a NAPA or AutoZone have the nuts? BTW the EX nuts seemed to tighten up just fine if one isn't using wheel covers.

[This message has been edited by George incleveland (edited 12-26-2001).]

[This message has been edited by George incleveland (edited 12-26-2001).]

[This message has been edited by George incleveland (edited 12-26-2001).]
 

·
Registered
Joined
·
254 Posts
the lx lug nuts have a nylon washer on the end that contacts the wheel. this washer is what holds the wheel cover in place. i think you will have to get them at honda. i leave the covers off myself.


------------------
2000 lx fern grey with mods
 
1 - 5 of 5 Posts
Top