Honda Odyssey Forum banner

Exhaust extension

1269 Views 6 Replies 3 Participants Last post by  blackwolf
Since y'all are detailin' the heck outa your Odysseys, why not detail that exhaust extension? At first, I thought I wanted one of those fat "rice burner" extensions, but when I noticed that the stock extension is a perfectly good piece of 300 series stainless, I decided to try to polish it. Once polished, it will stay bright and add an element of "newness" to the van. It really makes little sense to add a big bore extension, since the factory, in their wisdom, necked the 2 3/8" pipe down to 2" right before the extension. I guess one could cut the pipe off up where it is still 2 3/8" and gain a little flow. Anyway, I have no special equipment, so I used good ol' sandpaper, starting with 400 grit and ending with 1500 grit. It is not the mirror finish one gets with factory items, but it is darn close. It takes a lot of elbow grease to get rid of the lines caused when the pipe was extruded, but, it can be done. Too bad the whole system is not 300 (non-magnetic) stainless.

Jerry O.

------------------
2001 Odyssey GG LX
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top