Honda Odyssey Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
200 Posts
Discussion Starter #1
When I drying off the the underside of the hood the other day, I noticed that the foam rubber "gasket" under the hood--the one about 6-6" from the front edge--had come loose in a couple places. I was surprised that it didn't "clip" into a channel or was affixed by some other more secure method. It looks like it was just glued in a couple of places. Has anyone else seen this? I was just planning on reattaching it with some sort of adhesive. Any suggestions given the "harsh" environment under the hood?

------------------
Jeff

'01 SS EX
Cassette, Video System, Fog Lights, Splash Guards

See photos at:
http://www.fototime.com/inv/B5EC5C7BC6CFA07
 

·
Registered
Joined
·
139 Posts
Thanks for the tip. I checked mine and it was barely hanging on. Used a little super glue but I'll keep an eye on it. FYI, I also noticed that the rubber windshield trim was not snapped in properly up the driver's side A pillar. A little thumb pressure solved that problem. Sure hope that was the source of the intermittent buzzing noise I hear occasionally on hot days!

[This message has been edited by dlh2 (edited 06-06-2001).]

[This message has been edited by dlh2 (edited 06-06-2001).]
 
1 - 2 of 2 Posts
Top