Honda Odyssey Forum banner

how to jump scs with hds

11404 Views 3 Replies 2 Participants Last post by  cfhcar
Hello trying to find out how to " jump the scs with the hds" so I can check evap purge line and circuit. original post:
Hello,
Have 2006 odyssey with code p0443, doing the trouble shooting in 2005-2006 service manual have no vacuum, but could get it if I power the purge valve with battery directly.

in 18 in manual, it states jump the scs with the hds- if I do not do this can I still disconnect the pcm to check for wire continuity to valve?

I do not have the 33 OHMS as the book states, but I have about 30 at room temp.
Any ideas?
Thanks
Andrew
1 - 2 of 4 Posts
hds is honda diag. system i.e. factory scanner. jumping scs is a fuction test or control in scanner
i think you can if you disconnect battery frist and then remove the c socket at the ecm. from what i saw they want you to ohm the wire from the ecn to solinoid.
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top