I'm sure you can find out how to do in on YouTube or on Google.
I think:"You have to remove the bulkhead cover, the grill and the bumper cover to access the screws that hold the headlight in place. Clips can break easy. Not that simple a job unfortunately. Be cautious around the front SRS impact sensors in that area."
I found the above in another Ody post but not sure which year Ody they were taliking about.
On a 2000CRV, I just had to remove the bumper cover + license plate holder (around 4-6 screws and around 8 plastic clips). Then one plastic
clip on the underside of the same side front fender and pull that inner cover down and then I could get to that screw. That actually only took around 15 min to do.
Buffalo4
PS: It's not as simple as most vehicles, but then again, not too hard.
I think:"You have to remove the bulkhead cover, the grill and the bumper cover to access the screws that hold the headlight in place. Clips can break easy. Not that simple a job unfortunately. Be cautious around the front SRS impact sensors in that area."
I found the above in another Ody post but not sure which year Ody they were taliking about.
On a 2000CRV, I just had to remove the bumper cover + license plate holder (around 4-6 screws and around 8 plastic clips). Then one plastic
clip on the underside of the same side front fender and pull that inner cover down and then I could get to that screw. That actually only took around 15 min to do.
Buffalo4
PS: It's not as simple as most vehicles, but then again, not too hard.
