Honda Odyssey Forum banner

Run new speaker wire through A and B pillars

1563 1
Installing an amp and want to run new 16 or 14 GA wires for all the door speakers. Has anyone ran them through or around the existing door electrical connector grommet hose? I don't want to drill holes and have a wire flopping around loosely. The back doors seem possible, but can it be done on the front without removing the doors?
1 - 2 of 2 Posts

25 Posts
Discussion Starter · #2 ·

Back doors easy: remove seat belts and lower trim, route wire through conduit.

The front I removed the doors. Ran the cable through the conduit from inside the cab, but had to have it come out where the upper and lower conduit pieces are taped together. Then I drilled a hole in the door when it was off, to finish the routing.

While doing this I also dynamated the inside and outside door skins and installed some Infinity Kappa 6.5" components in the front and coaxials in the back. These are 90 W and 75 W RMS, 2 ohm speakers respectively. They will be ran by an old Hyfonics Taurus X amp rated at 4X50w RMS into a 4 ohm load which I mounted under the pass seat.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.