Those don't look like the right size bushings, but the camera can always lie.

Also, prying them open may be deceiving too, since it says 23 and the other size is 24. Do they knock when you wiggle the bar?

 

I tried it only on one side. Need to raise both sides and wiggle the bar. In this picture, I am not prying on them, just checking the gap. Need to check both sides. I tried prying it under the bar with the pry bar and i can wiggle it up and down.

This is what i bought -> 51306-S3V-A00 - Genuine Honda Bush, Stabilizer Holder . It says 23.

 

Really hard to tell from photo's if they are the wrong size. My experience is that even when they are worn they don't really clunk, its usually the links or something else. Of course, as my wife reminds me, I've been wrong before.

 

The links are fine. I changed them along with bushings last October. Strut and its components are new. Control arm bushings are poly and ball joint looks fine. Also the axles.

 

Really hard to tell from photo's if they are the wrong size. My experience is that even when they are worn they don't really clunk, its usually the links or something else. Of course, as my wife reminds me, I've been wrong before.

Oh they clunk when worn; if you've never heard it you didn't wait long enough. Sounds just like the link being bad on each side.

My wife also gives me reminders... 🤣