Are you using a press?

 

It's The press alternative it's a kit with cup and assorted sized adapters that press bearing out

 

Yes, I did make an attempt but after some push 3 to 5 seconds with cordless impact half inch drive large Milwaukee it stopped where it is now

 

I havn't looked lately at the manual, is there a snap ring you have to remove first.
Heat the hub a bit may help also.

 

Yes I removed snap ring

 

 

Your 100% sure your cup has a larger inner diameter than the bearings outer diameter?

Your also sure you have the cup centered so the bearing won't touch the cup?

 

Another autozone mistake, wrong kit, cup was to small wouldn't allow bearing to be pressed into cup. I took the knuckle off and pounded it out by hand

 

DIY Front wheel bearing 2008 Touring

Had to replace wheel bearings on 2 vehicles so I thought to try on vehicle (in-situ) using just wheel bearing kit. No slide hammer. I did not use any air/power tools so all descriptions will be manual. Tools: - Axle nut socket set (rented at Pepboys) -Wrenches mm 10, 17, 19 -Sockets mm 10, 12...

www.odyclub.com

Although its in the 3rd gen forum, same tools, same process, same for other car brands....